Outside Iowa: Keeping your turkey calls sharp
I am a self-proclaimed turkey call fanatic. My wife will simply roll her eyes if you were to ask her about how many calls I currently have.
It’s not like I chase her around the house running three or four of them at the same time hoping to get her attention.
Ok, maybe I do run calls in the house more than I should, but only during this time of year.
I love turkey calls almost as much as I do hunting turkeys.
I have been collecting them for years and appreciate how each and every call is different and takes the right maneuver to attain the sexiest pitch. Between what I have purchased and built myself, I have accumulated more than 100 calls. Is that normal?
Through the years of being a call junkie I have learned to maintain the sounds they are supposed to make a little maintenance is required.
It’s simple, but far too many hunters struggle with producing the correct calls. Usually, they just give up and buy a new one.
Invest in a piece of sandpaper and in a couple short seconds, you can have your call purring like a lonely hen.
Box calls need chalk and a little brushing with sandpaper at times, but don’t over do it. When the paddle begins to slide across the sidewalls without making much noise, or the sound is real scratchy, chances are good you need to put a coat of chalk on it. About twice a season depending on how much I use it, or if the call gets wet, I will recondition the paddle and sidewalls with a piece of 120 grit sandpaper. Sand with the grain.
A quarter turn either way on the screw that holds the paddle to the box will adjust the pitch, mess with it until it sounds right.
That screw rarely needs adjusted, but if you feel the sound quality has been lost, a quarter turn in will heighten the pitch, and a quarter turn out will lower it. Less is more.
Friction calls typically need resurfacing daily—at least. You can use larger grit sandpaper for glass calls, but a “brillo” pad will totally suffice for slate.
Run the sandpaper or pad across the call, back and forth in one direction, not in circles. Do this until the surface is consistent, and any smudges or marks are gone.
I suggest leaving the remaining dust on the surface of the call, as it will give you more control with the striker.
The striker is the next thing that needs reconditioned.
Take the striker between your thumb and forefinger and spin it while brushing the tip of it with the sand paper in a downward motion at a 45-degree angle. Once the striker and pot are finished, give it a try and make sure you have attained the desired sound.
I prefer to resurface my pots at each hunt—it allows me to stay in control of the sound I am trying to produce.
Also, avoid touching the friction areas on both box and slate calls with your fingers.
The oils in your skin will deaden the calls quicker than anything. And avoid moisture at all costs.
A little tender loving care for your turkey calls will up your odds of pulling off the perfect “Tom Foolery.”
Plus it will make me feel better knowing there are far more quality sounding calls out there this spring.
Good luck and don’t hesitate to contact me with any questions!
Live It Up!
Thomas resides with his wife and two children in Guthrie Center, Iowa. He is the Managing Editor with North American Fisherman, official publication for North American Fishing Club. For questions or archived articles please visit www.outsideiowa.com; tha481@gmail.com
